Part Number Hot Search : 
AHD22 BR104 URAM3TS3 4HC4050 74LVC128 PFN2028 10A05 B0419
Product Description
Full Text Search
 

To Download NJU7040 Datasheet File

  If you can't view the Datasheet, Please click here to try to view without PDF Reader .  
 
 


  Datasheet File OCR Text:
 NJU7040
Input/Output Full-Swing High Output Current Single C-MOS Operational Amplifier
GENERAL DESCRIPTION The NJU7040 is a C-MOS operational amplifier permitting a full-swing input and output in full-swing under high load. Based on C-MOS technology, there are excellent features such as high output current, low current consumption, low operating voltage, and very high input impedance. FEATURES Operating Voltage: Input/Output Full-Swing High Output Current: Input Offset Voltage: Wide Input Common Mode Voltage Range: Operating Current: High Input Impedance: Low Input Bias Current: Ground Sensing Tiny Package: PIN CONFIGURATION PACKAGE OUTLINE
NJU7040F
2.2V to 5.5V 40mA at VO=0V VIO=10mV max. VSS to VDD IDD=350A typ. (at VDD=3V) 1T Typ. IIB=1pA typ. MTP5
1 2 3
NJU7040F (Top View)
+ -
5
4
PIN FUNCTION 1. +INPUT 2. VSS 3. -INPUT 4. OUTPUT 5. VDD
Ver.2004-06-10
-1-
NJU7040
ABSOLUTE MAXIMUM RATINGS
PARAMETER Supply Voltage Common Mode Input Voltage Range Differential Input Voltage Range Power Dissipation Output Current Operating Temperature Range Storage Temperature Range SYMBOL VDD VICM VID PD IO Topr Tstg RATINGS 7 0 to 7 (Note 1) 7 200 [MTP5] 390 [MTP5] (Note 2) 520 [MTP5] (Note 3) 75 [MTP5] -40 to +85 -55 to +125 UNIT V V V mW mA uC uC
(Note 1) For supply voltage less than 7V, the absolute maximum input voltage is equal to the supply voltage. (Note 2) On the PCB " EIA/JEDEC (76.2x11.43x1.6mm, two layers, FR-4) " (Note 3) On the PCB " EIA/JEDEC (76.2x11.43x1.6mm, four layers, FR-4) "
Power Dissipation vs. Ambient Temperature
Package Type (1)MTP5[Four Layer] : PD= -5.2(mW/C) (2)MTP5[Tw o Layer] : PD= -3.9(mW/C)
(Note 4) Please do not exceed "Power Dissipation (PD)" the power dissipation in IC is absolutely indicated to be in the maximum rating. See the figure "Power Dissipation vs. Ambient Temperature" for information on temperature derating of this device.
600
Power Dissipation P D (mW)
500 400 300 200 100 0
(1) (2)
25
50
75
100
Ambient Temperature Ta (C)
OPERATING VOLTAGE (Ta=25uC)
PARAMETER Supply Voltage SYMBOL V DD RATINGS 2.2 to 5.5 UNIT V
-2-
Ver.2004-06-10
NJU7040
ELECTRICAL CHARACTERISTICS DC CHARACTERISTICS
PARAMETER Operating Current Input Offset Voltage Input Bias Current Input Offset Current Large Signal Voltage Gain Common Mode Rejection Ratio SYMBOL I DD VIO IB IIO AV CMR TEST CONDITION No Signal Apply MIN. 70 44 TYP. 450 1 1 90 60
(VDD=5V, Ta=25uC)
MAX. 700 10 UNIT A mV pA pA dB dB
R L =10k to 2.5V, Vo=2.5V2.4V CMR+: 2.5V V CM 5V CMR-: 0V V CM 2.5V (Note 5) 4.0V V DD 5.5V, V CM =V DD /2 R L =10k to 2.5V R L =10k to 2.5V R L =600 to 2.5V R L =600 to 2.5V V O =2.5V V O =2.5V CMR 44dB
Supply Voltage Rejection Ratio Output Voltage1 Output Voltage2 Output Source Current Output Sink Current Input Common Mode Voltage Range
SVR VOH1 VOL1 VOH2 VOL2 I SOURCE I SI NK VICM
55 4.95 4.9 70 70 0
85 -
0.05 0.1 5
dB V V V V mA mA V
(Note 5) CMR is represented by either CMR+ or CMR- has lower value.
AC CHARACTERISTICS
PARAMETER Unity Gain Bandwidth Total Harmonic Distortion Equivalent Input Noise Voltage SYMBOL GB THD V NI TEST CONDITION R L =10k to 2.5V f=1kHz, VIN=1Vpp, AV=0dB f=1kHz MIN. TYP. 0.8 0.05 40
(VDD=5V, Ta=25uC)
MAX. UNIT MHz % nV/Hz
TRANSIENT CHARACTERISTICS
PARAMETER Slew Rate SYMBOL SR TEST CONDITION R L =10k to 2.5V MIN. TYP. 0.85
(VDD=5V, Ta=25uC)
MAX. UNIT V/s
Ver.2004-06-10
-3-
NJU7040
ELECTRICAL CHARACTERISTICS DC CHARACTERISTICS
PARAMETER Operating Current Input Offset Voltage Input Bias Current Input Offset Current Large Signal Voltage Gain Common Mode Rejection Ratio SYMBOL I DD VIO IB IIO AV CMR TEST CONDITION No Signal Apply MIN. 70 42 TYP. 350 1 1 90 60
(VDD=3V, Ta=25uC)
MAX. 600 10 UNIT A mV pA pA dB dB
R L =10k to 1.5V, Vo=1.5V1.4V CMR+: 1.5V V CM 3V CMR-: 0V V CM 1.5V (Note 6) 2.7V V DD 4.0V, V CM =V DD /2 R L =10k to 1.5V R L =10k to 1.5V R L =600 to 1.5V R L =600 to 1.5V V O =1.5V V O =1.5V CMR 42dB
Supply Voltage Rejection Ratio Output Voltage1 Output Voltage2 Output Source Current Output Sink Current Input Common Mode Voltage Range
SVR VOH1 VOL1 VOH2 VOL2 I SOURCE I SI NK VICM
50 2.95 2.9 30 30 0
80 40 40 -
0.05 0.1 3
dB V V V V mA mA V
(Note 6) CMR is represented by either CMR+ or CMR- has lower value.
AC CHARACTERISTICS
PARAMETER Unity Gain Bandwidth Total Harmonic Distortion Equivalent Input Noise Voltage SYMBOL GB THD V NI TEST CONDITION R L =10k to 1.5V f=1kHz, VIN=1Vpp, AV=0dB f=1kHz MIN. TYP. 0.8 0.05 40
(VDD=3V, Ta=25uC)
MAX. UNIT MHz % nV/Hz
TRANSIENT CHARACTERISTICS
PARAMETER Slew Rate SYMBOL SR TEST CONDITION R L =10k to 1.5V MIN. TYP. 0.7
(VDD=3V, Ta=25uC)
MAX. UNIT V/s
-4-
Ver.2004-06-10
NJU7040
DC CHARACTERISTICS
PARAMETER Operating Current Input Offset Voltage Input Bias Current Input Offset Current Large Signal Voltage Gain Common Mode Rejection Ratio SYMBOL I DD VIO IB IIO AV CMR TEST CONDITION No Signal Apply MIN. 70 30 TYP. 300 1 1 90 60
(VDD=2.2V, Ta=25uC)
MAX. 500 10 UNIT A mV pA pA dB dB
R L =10k to 1.1V, Vo=1.1V1.0V CMR+: 1.1V V CM 2.2V CMR-: 0V V CM 1.1V (Note 7) 2.2V V DD 2.7V, V CM =V DD /2 R L =10k to 1.1V R L =10k to 1.1V R L =600 to 1.1V R L =600 to 1.1V V O =1.1V V O =1.1V CMR 30dB
Supply Voltage Rejection Ratio Output Voltage1 Output Voltage2 Output Source Current Output Sink Current Input Common Mode Voltage Range
SVR VOH1 VOL1 VOH2 VOL2 I SOURCE I SI NK VICM
45 2.15 2.1 10 10 0
70 15 15 -
0.05 0.1 2.2
dB V V V V mA mA V
(Note 7) CMR is represented by either CMR+ or CMR- has lower value.
AC CHARACTERISTICS
PARAMETER Unity Gain Bandwidth Total Harmonic Distortion Equivalent Input Noise Voltage SYMBOL GB THD V NI TEST CONDITION R L =10k to 1.1V f=1kHz, VIN=1Vpp, AV=0dB f=1kHz MIN. TYP. 0.8 0.05 40
(VDD=2.2V, Ta=25uC)
MAX. UNIT MHz % nV/Hz
TRANSIENT CHARACTERISTICS
PARAMETER Slew Rate SYMBOL SR TEST CONDITION R L =10k to 1.1V MIN. TYP. 0.6
(VDD=2.2V, Ta=25uC)
MAX. UNIT V/s
[CAUTION] The specifications on this data book are only given for information, without any guarantee as regards either mistakes or omissions. The application circuits in this data book are described only to show representative usages of the product and not intended for the guarantee or permission of any right including the industrial rights.
Ver.2004-06-10
-5-


▲Up To Search▲   

 
Price & Availability of NJU7040

All Rights Reserved © IC-ON-LINE 2003 - 2022  

[Add Bookmark] [Contact Us] [Link exchange] [Privacy policy]
Mirror Sites :  [www.datasheet.hk]   [www.maxim4u.com]  [www.ic-on-line.cn] [www.ic-on-line.com] [www.ic-on-line.net] [www.alldatasheet.com.cn] [www.gdcy.com]  [www.gdcy.net]


 . . . . .
  We use cookies to deliver the best possible web experience and assist with our advertising efforts. By continuing to use this site, you consent to the use of cookies. For more information on cookies, please take a look at our Privacy Policy. X